| Table of Contents |
|---|
Connector Installation Service
Package Downloading
To download the connector package log in Koongo Store and proceed to My Modules for Download:
Installation Proceedure
Turn off Compiler
Before you start the installation process turn off Magento compiler. To do so, navigate to System → Tools → Compilation and disable compilation. You may turn it on after connector installation.
If you don't take this step you get probably Fatal error: Class 'Nostress_Nscexport_Helper_Data' not found in XXX on line XXX.
- Solution for this error: re-compile Magento files.
Magento Connect Manager
The most convenient way how to install the connector is through Magento Connect Manager.
- Log-in to your Magento Connect Manager, running probably on URL http://www.your-magento.com/downloader/.
- Upload the downloaded tgz package, as shown on the screenshot below:
Manuall Installation
Unpack the downloaded tgz package localy and copy the content to your Magento installation folder using FTP or SSH/SCP client. Ignore the file package.xml in tgz package.
Post-installation Steps
Cache Refresh
Navigate to System → Cache Management and refresh ALL cache.
Log-out and Log-in
If you don't take this step, you may get 404 Not Found error in Koongo Connector. Is is NOT a bug of connector but known limitation of Magento.
Enable Flat Catalog
Koongo Connector uses Flat Product and Flat Category data, so please make you sure you have enabled these two settings. You can enable Flat by clicking on the link in the notice or navigate to Configuration → System → Catalog → Frontend:
- Use Flat Catalog Category = Yes
- Use Flat Catalog Product = Yes
Reindex Catalog and Category Index
Subsequently, navigate to System → Index Management and reindex Category Flat Data and Product Flat Data index:
Run Configuration Check
To make you sure all configuration requirements are met run Configuration Check.
Next step
Troubleshooting
Common Magento issues related to module installation: