Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 46 Next »

Table of Contents

Connector or Service?

Note that for Magento (and only for Magento) we have two products - Connector and Service. So first you need to decide if you want to use Connector or Service. Please review the features of both products we have for Magento before you proceed with installation.

 

Following instructions are intended for Connector only!

Connector Installation Servise

Did you know that you may order professional connector installation by our support team? Just place an order of Connector Installation servise!

Package Downloading

To download the connector package log in Koongo Store and proceed to My Modules for Download:

Installation Proceedure

Turn off Compiler

Before you start the installation process turn off Magento compiler. To do so, navigate to System → Tools → Compilation and disable compilation. You may turn it on after connector installation.

If you don't take this step you get probably Fatal error: Class 'Nostress_Nscexport_Helper_Data' not found in XXX on line XXX. 

  • Solution for this error: re-compile Magento files.

Magento Connect Manager

The most convenient way how to install the connector is through Magento Connect Manager.

  1. Log-in to your Magento Connect Manager, running probably on URL http://www.your-magento.com/downloader/.
  2. Upload the downloaded tgz package, as shown on the screenshot below:

Manuall Installation

Unpack the downloaded tgz package localy and copy the content to your Magento installation folder using FTP or SSH/SCP client. Ignore the file package.xml in tgz package.

Post-installation Steps

Cache Refresh

Navigate to System → Cache Management and refresh ALL cache.

Log-out and Log-in

If you don't take this step, you may get 404 Not Found error in Koongo Connector. Is is NOT a bug of connector but known limitation of Magento.

Enable Flat Catalog

Koongo Connector uses Flat Product and Flat Category data, so please make you sure you have enabled these two settings. You can enable Flat by clicking on the link in the notice or navigate to Configuration → System → Catalog → Frontend:

  • Use Flat Catalog Category = Yes
  • Use Flat Catalog Product = Yes

Reindex Catalog and Category Index

Subsequently, navigate to System → Index Management and reindex Category Flat Data and Product Flat Data index:


Run Configuration Check

To make you sure all configuration requirements are met run Configuration Check.

Next step

Activation

Troubleshooting

Common Magento issues related to module installation:

 

  • No labels